Mounting a Half-Duplex to Full-Duplex Converter on a Flat Surface
About this task
Refer to Installing a Half-Duplex to Full-Duplex Converter for installation options for the Half-Duplex to Full-Duplex Converter.
To install a Half-Duplex to Full-Duplex Converter unit on a flat surface, follow these steps:
Procedure
- Attach the four rubber feet (included) to the bottom of the converter, one at each corner.
- Set the converter on a flat, stable surface.
- Connect the converter to its power adapter, following the instructions in Connecting a Half-Duplex to Full-Duplex Converter to its Power Adapter.
- Connect the full-duplex ports (FD1 - FD4) to the switch.
- Connect the half-duplex ports (HD1 - HD4) to your half-duplex devices.