Mount a Half-Duplex to Full-Duplex Converter on a Wall

Refer to Install a Half-Duplex to Full-Duplex Converter for installation options for the Half-Duplex to Full-Duplex Converter.

To mount a Half-Duplex to Full-Duplex Converter unit on a wall, follow these steps:

  1. Drill two holes in the wall, each 4 mm (0.16 in.) in diameter.

    The holes should be 10.5 cm (4.13 in.) apart so that they correspond to the locations of the holes in the bottom of the converter.

  2. Insert an anchor bolt (not provided) into each hole in the wall.
  3. Place a screw (not provided) into each anchor bolt and tighten so that the screw head protrudes slightly from the wall.
  4. Place the converter onto the screws and gently lower it so that it locks into place.
  5. Connect the converter to its power adapter, following the instructions in Connect a Half-Duplex to Full-Duplex Converter to its Power Adapter.
  6. Connect the full-duplex ports (FD1 - FD4) to the switch.
  7. Connect the half-duplex ports (HD1 - HD4) to your half-duplex devices.