Configuration Example for MLAG
This configuration example shows how to configure
MLAG (Multi-switch Link Aggregation Group) with VXLAN. In the following example:
- The MLAG switches are operating as independent OSPF (Open Shortest Path First) routers. They must use
different router IDs.
- The same local endpoint address is configured on both
switches.
- The ISC link also functions as a routed link with a high metric. The
link is also used when one switch loses all underlay connectivity.
Switch #1 Configuration
create vlan “ospf_loop”
enable loopback-mode vlan ospf_loop
configure vlan ospf_loop ipaddress 10.10.10.141 255.255.255.255
enable ipforwarding vlan ospf_loop
config ospf routerid 10.10.10.141
create vlan “route-isc”
configure vlan route-isc ipaddress 100.0.0.141 255.255.255.0
enable ipforwarding vlan route-isc
configure ospf vlan route-isc cost 65535
create vlan “vltep”
enable loopback-mode vlan vltep
configure vlan vltep ipaddress 10.10.10.200 255.255.255.255
enable ipforwarding vlan vltep
configure virtual-network local-endpoint ipaddress 10.10.10.200 vr “VR-Default”
Switch #2 Configuration
create vlan “ospf_loop”
enable loopback-mode vlan ospf_loop
configure vlan ospf_loop ipaddress 10.10.10.142 255.255.255.255
enable ipforwarding vlan ospf_loop
config ospf routerid 10.10.10.142
create vlan “route-isc”
configure vlan route-isc ipaddress 100.0.0.142 255.255.255.0
enable ipforwarding vlan route-isc
configure ospf vlan route-isc cost 65535
create vlan “vltep”
enable loopback-mode vlan vltep
configure vlan vltep ipaddress 10.10.10.200 255.255.255.255
enable ipforwarding vlan vltep
configure virtual-network local-endpoint ipaddress 10.10.10.200 vr “VR-Default”
Print
this page
Email this topic
Feedback
View PDF
Download EPUB