-
To create or delete an ERPS (Ethernet Ring Protection Switching)
ring, use the following commands:
create erps ring-name
delete erps ring-name
-
To add or delete a control VLAN (Virtual LAN) on the ERPS ring, use the following commands:
configure erps ring-name
add
control {vlan} vlan_name
configure erps ring-name
delete
control {vlan} vlan_name
-
To add or delete a protected VLAN on the ERPS ring, use
the following commands:
configure erps ring-name add protected {vlan} vlan_name
configure erps ring-name delete protected {vlan} vlan_name
-
To add ring ports on the ERPS ring (this ring's ports connect the switch to the ERPS
ring), use the following command:
configure erps ring-name
ring-ports [east | west] port
-
To add ring ports on the ERPS ring, use the following
command:
configure
erps ring-name ring-ports [east | west] port
-
To configure CFM for ERPS ring ports, use the following command:
configure erps ring_name
cfm
port [east | west] [add | delete] group
group_name
-
To delete ring ports on the ERPS ring, use the following
command:
unconfigure
erps ring-name ring-ports west
-
To add or delete RPL (ring protection link) owner
configuration for the ERPS ring, use the following commands:
configure erps ring-name protection-port port
unconfigure erps ring-name protection-port
-
To add or delete RPL (ring protection link) neighbor
configuration for the ERPS ring, use the following commands:
configure erps ring-name neighbor-port port
unconfigure erps ring-name neighbor-port
-
To add or delete ERPS revert operation along with the
wait-to-restore time interval, use the following commands:
configure
{erps} ring-name revert [ enable | disable ]
-
To configure the periodic timer, use the following
command:
configure
{erps} ring-name timer periodic [ default | milliseconds ]
-
To configure the guard timer, use the following
command:
configure
{erps} ring-name timer guard [ default | milliseconds ]
-
To configure the hold-off timer, use the following
command:
configure
{erps} ring-name timer hold-off [ default | milliseconds ]
-
To configure the wait-to-restore timer, use the following
command:
configure
{erps} ring-name timer wait-to-restore [ default | milliseconds ]
-
To rename the ERPS ring/sub-ring, use the following
command:
configure
erps old-ring-name name new-ring-name
-
To enable or disable ERPS, use the following
commands:
-
To enable or disable an existing ERPS ring/sub-ring, , use
the following command:
enable erps ring-name
disable erps ring-name
-
Run or clear force and manual switch triggers, or clear
command to the ERPS ring/sub-ring.
configure
erps ring-name
dynamic-state [force-switch | manual-switch | clear] port
slot:port
-
To display global information for ERPS, use the following
command:
show erps
-
To display specific details about an ERPS ring, use the
following command:
show erps
ring-name
-
To display ERPS statistics, use the following
command:
show erps
ring-name statistics
-
To clear statistics on an ERPS ring, use the following
command:
clear
counters erps ring-name
-
To debug ERPS, use the following commands:
debug erps [options]
debug erps show ring-name
Print
this page
Email this topic
Feedback
View PDF
Download EPUB