Enabling/Disabling the USB Port

For enhanced security, you can enable or disable a USB port on a switch. The USB port is enabled by default.

Supported Platforms

ExtremeSwitching and Summit X450-G2, X460-G2, X670-G2, X770, X870, X440-G2, X620, X690, X590 series switches.

Limitations

Stack support is not available. You need to enable this command individually on each node in a stack.

Using USB Port Commands

To enable the USB port, use the following command:

enable switch usb

To disable the USB port, use the following command:

disable switch usb

To show the status of the USB port, use the following command:

show switch usb