Configuring QoS on SummitStack and Summit Family Switches

QoS on SummitStack and Summit Family Switches shows the QoS (Quality of Service) configuration components for SummitStack and Summit family switches.

QoS on SummitStack and Summit Family Switches

QoS Configuration Guidelines for SummitStack and Summit Family Switches

The considerations below apply to QoS on SummitStack and Summit family switches:

The following QoS features share resources:
- ACL (Access Control List)s
- dot1p
- VLAN (Virtual LAN)-based QoS
- Port-based QoS
You might receive an error message when configuring a QoS feature in the above list; it is possible that the shared resource is depleted. In this case, unconfigure one of the other QoS features and reconfigure the one you are working on.
On a SummitStack, you cannot create QoS profile QP7. This QoS profile is reserved for system control traffic.
These switches allow dynamic creation and deletion of QoS queues, with QP1 and QP8 always available.
ACL egress rate-limit meters are supported only on all platforms.

Published March 2020prev | next