Using the Edit Command
A VI-like editor is available on the switch to edit policies. There are
many commands available with the editor. For information about the editor commands, use any
tutorial or documentation about VI. The following is only a short introduction to the
editor.
The editor operates in one of two modes: command and input.
-
To edit a policy file on the switch by launching the
editor, enter the command:
edit policy
filename.pol
When a file first opens, you are in
the command mode.
-
To write in the file, use the keyboard arrow keys to
position your cursor within the file, then press one of the following
keys to enter input mode:
-
[i]—Inserts text ahead of the
initial cursor position.
-
[a]—Appends text after the
initial cursor position.
-
To escape the input mode and return to the command mode,
press the [Esc] key.
Several commands can be used from the command mode. The following commands are the most
commonly used:
- [dd]—Deletes the current line.
- [yy]—Copies the current line.
- [p]—Pastes the line copied.
- [:w]—Writes (saves) the file.
- [:q]—Quits the file if no changes were
made.
- [:q!]—Forcefully quits the file without saving
changes.
- [:wq]—Writes and quits the file.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB