This is a template for configuring network parameters for VoIP phone support without 802.1X authentication. The profile is triggered after an LLDP (Link Layer Discovery Protocol) packet is detected on the port.
Note
The MetaData information is used by the Ridgeline to create a user-friendly interface to modify the variables. You can ignore the MetaData while using the CLI.
#******************************** # Last Updated: April 11, 2007 # Tested Phones: Avaya 4610, 4620, 4625 # Requirements: LLDP capable devices #******************************** # @MetaDataStart # @ScriptDescription "This is a template for configuring network parameters for VoIP phones support LLDP but without authentication. The module is triggered through the detection of an LLDP packet on the port. The following network side configuration is done: enable SNMP traps, QOS assignment, adjust POE reservation values based on device requirements, add the voiceVlan to the port as tagged. " # @VariableFieldLabel "Voice VLAN name" set var voicevlan voiceavaya # @VariableFieldLabel "Send trap when LLDP event happens (true or false)" set var sendTraps false # @VariableFieldLabel "Set QoS Profile (true or false)" set var setQuality false # @MetaDataEnd # if (!$match($EVENT.NAME,DEVICE-DETECT)) then create log message Starting_LLDP_Generic_Module_Config # VoiceVLAN configuration configure vlan $voicevlan add port $EVENT.USER_PORT tagged #SNMP Trap if (!$match($sendTraps,true)) then create log message Config_SNMP_Traps enable snmp traps lldp ports $EVENT.USER_PORT enable snmp traps lldp-med ports $EVENT.USER_PORT else disable snmp traps lldp ports $EVENT.USER_PORT disable snmp traps lldp-med ports $EVENT.USER_PORT endif #Link Layer Discovery Protocol-Media Endpoint Discover create log message Config_LLDP configure lldp port $EVENT.USER_PORT advertise vendor-specific med capabilities configure lldp port $EVENT.USER_PORT advertise vendor-specific dot1 vlan-name vlan $voicevlan configure lldp port $EVENT.USER_PORT advertise vendor-specific med policy application voice vlan $voicevlan dscp 46 configure lldp port $EVENT.USER_PORT advertise vendor-specific med power-via-mdi #Configure POE settings per device requirements create log message Config_POE configure inline-power operator-limit $EVENT.DEVICE_POWER ports $EVENT.USER_PORT #QoS Profile if (!$match($setQuality,true)) then create log message Config_QOS configure port $EVENT.USER_PORT qosprofile qp7 endif endif if (!$match($EVENT.NAME,DEVICE-UNDETECT) && $match($EVENT.DEVICE_IP,0.0.0.0)) then create log message Starting_LLDP_Generic_UNATUH_Module_Config if (!$match($sendTraps,true)) then create log message UNConfig_SNMP_Traps disable snmp traps lldp ports $EVENT.USER_PORT disable snmp traps lldp-med ports $EVENT.USER_PORT endif create log message UNConfig_LLDP unconfig lldp port $EVENT.USER_PORT if (!$match($setQuality,true)) then create log message UNConfig_QOS unconfig qosprofile ports $EVENT.USER_PORT endif unconfig inline-power operator-limit ports $EVENT.USER_PORT endif if (!$match($EVENT.NAME,DEVICE-UNDETECT) && !$match($EVENT.DEVICE_IP,0.0.0.0)) then create log message DoNothing_0.0.0.0 create log message $EVENT.TIME endif create log message End_LLDP_Generic_Module_Config
Print
this page
Email this topic
Feedback
View PDF
Download EPUB