Updating the Local Network Login Password

Passwords are case-sensitive. Passwords must have a minimum of zero characters and a maximum of 32 characters.

Update the password of an existing local network login account with the following command:
configure netlogin local-user user_name
where user_name specifies the name of the existing local network login account.
After you enter the local network login user name, press [Enter].
The switch prompts you to enter a password.
At the prompt, enter the new password and press [Enter].
The switch then prompts you to reenter the password.
If you attempt to create a password with more than 32 characters, the switch displays the following message after you re-enter the password:
```
Password cannot exceed 32 characters
```
The following example modifies the password for the existing local network login account megtest.The following is a sample display from this command:
```
configure netlogin local-user megtest
password: <Enter the new password. The switch does not display the password.>
Reenter password: <Re-enter the new password. The switch does not display the password.>
```