Configuring Software-Controlled Redundant Ports

When provisioning software-controlled redundant ports, configure only one side of the link as redundant. To enable the software-controlled redundant port feature, the primary and redundant ports must have identical VLAN (Virtual LAN) membership.

In the following figure only the ports on switch C would be configured as redundant.

To configure a software-controlled redundant port, use the following command:
configure ports primaryPort redundant secondaryPort {link [on | off]}

The first port specified is the primary port. The second port specified is the redundant port.
Unconfigure a software-controlled redundant port, use the following command and enter the primary port(s):
unconfigure ports port_list redundant
To configure the switch for the Smart Redundancy feature, use the following command:
enable smartredundancy port_list
To disable the Smart Redundancy feature, use the following command:
disable smartredundancy port_list

Published March 2020prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback