ERPS Version 2 Commands

To set the rings to which to propagate topology change events, use the following command:
configure erps ring-name [add | delete] topology-change ring-list
To enable or disable the ability of ERPS (Ethernet Ring Protection Switching) to allow the topology-change bit to be set (to send out Flush events), , use the following commands:

enable erps ring-name topology-change

disable erps ring-name topology-change
To add or delete a sub-ring to the main ring, use the following command:
configure {erps} ring-name [add | delete] sub-ring-name sub_ring
To configure the wait-to-block timer, use the following command:
configure {erps} ring-name timer wait-to-block [ default | milliseconds]
To add or delete an ERPS sub-ring to the EAPS (Extreme Automatic Protection Switching) domain, use the following commands:

configure {erps} ring-name notify-topology-change {eaps} domain_name

unconfigure {erps} ring-name notify-topology-change {eaps} domain_name
To configure a wait-to-block timer, use the following command:
configure {erps} ring-name timer wait-to-block [ default | milliseconds]
To configure sub-ring mode, use the following command:
configure erps ring_name subring-mode [no-virtualChannel | virtualChannel]

Published March 2020prev | next