Displaying Switch Load Sharing

You can display static and dynamic load sharing. In the link aggregation displays, the types are shown by the following aggregation controls:

To verify your configuration, use the following command:
show ports sharing
Verify LACP configuration, use the following command:
show lacp
To display information for the specified LAG (Link Aggregation Group), use the following command:
show lacp lag group-id {detail}
To display LACP information for a port that is a member of a LAG, use the following command:
show lacp member-port port {detail}

Refer to Displaying Port Information for information on displaying summary load-sharing information.
To clear the counters, use the following command:
clear lacp counters
To display the LACP counters, use the following command:

You can display the LACP counters for all member ports in the system by using:

show lacp counters
To display information for a health check LAG, use the following command:
show sharing health-check

Published March 2020prev | next