The following configuration example shows the Extreme Networks switch configuration needed to support the 802.1X network login example.
Note
In the following sample configuration, any lines marked (Default) represent default settings and do not need to be explicitly configured.create vlan “temp” create vlan “corp” configure vlan “default” delete ports 4:1-4:4 # Configuration Information for VLAN corp # No VLAN-ID is associated with VLAN corp. configure vlan “corp” protocol “ANY” (Default) configure vlan “corp” ipaddress 10.203.0.224 255.255.255.0 # Configuration Information for VLAN Mgmt configure vlan “Mgmt” ipaddress 10.10.20.30 255.255.255.0 # Network Login Configuration configure netlogin vlan “temp” enable netlogin dot1x enable netlogin ports 1:10-1:14, 4:1-4:4 dot1x # RADIUS Configuration configure radius netlogin primary server 10.0.1.2 1812 client-ip 10.10.20.30 vr “VR-Mgmt” configure radius netlogin primary shared-secret purple enable radius
The following example is for the FreeRADIUS server; the configuration might be different for your RADIUS (Remote Authentication Dial In User Service) server:
#RADIUS Server Setting, in this example the user name is eaptest eaptest Auth-Type := EAP, User-Password == "eaptest" Session-Timeout = 120, Termination-Action =1
For information about how to use and configure your RADIUS server, refer to Configuring the RADIUS Client and the documentation that came with your RADIUS server.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB