Print this pagePrint this page

Email this topicEmail this topic

View PDFView PDF

Download EPUBDownload EPUB

Configuring Extended Edge Switching Topology with Partial Automation (Auto-configuration)

The Extended Edge Switching auto-configuration feature allows the controlling bridge switch in an Extended Edge Switching topology to detect new bridge port extenders (BPEs) connected to ports not configured as cascade ports, and automatically configure cascade ports, extended slots, and LAGs/MLAGs on cascade ports. This capability allows for the more rapid and accurate setup of an Extended Edge Switching architecture, but still requires some manual configuration. To further reduce manual configuring, consider using full automation (see Configuring Extended Edge Switching Topology with Full Automation)

Note

Note

Auto-configuration is disabled by default. If auto-configuration is enabled, Extended Edge Switching ports cannot be manually configured.

Cascade port connections to a BPE are automatically grouped into a LAG with the first detected connection set as the master logical port. Automatic LAG grouping occurs even if there is only a single connection to the BPE. With auto-configuration enabled, additional connections added after the initial Extended Edge Switching configuration is established are automatically added to the LAG. If you remove connection(s) and want the port(s) removed from the LAG, you must do this manually (see Adding and Deleting Ports in a Load-Sharing Group).

To use auto-configuration:
  1. Attach BPEs as desired.
  2. (Optional) Create the MLAG peer relationship between redundant CBs and ensure that both CBs are up (see Redundant Controlling Bridges). The rest of the MLAG setup for redundant CBs is handled automatically.
  3. Enable VPEX mode:

    enable vpex

  4. Reboot the CB(s) to allow the VPEX mode command to take effect.
  5. Enable auto-configuration:

    enable vpex auto-configuration

  6. The configuration applied by automation is not automatically saved. Save the configuration:
    • Manually: save configuration {primary | secondary | existing-config | new-config}
    • Automatically: save configuration automatic {every minutes {primary | secondary | existing-config | new-config} | never}

The partial automation process detects the new BPEs connected to ports not configured as cascade ports, and automatically configures cascade ports, extended slots, and LAGs on cascade ports.

To show auto-configuration status, use the following command:

show vpex

To disable auto-configuration, use the following command:

disable vpex auto-configuration

For information about troubleshooting an Extended Edge Switching topology, see Troubleshooting an Extended Edge Switching Topology.

Published March 2020prev | next

Email this topicEmail this topic

Print this pagePrint this page