Enabling EAPS and Verify EAPS Status

  1. Enable the EAPS (Extreme Automatic Protection Switching) protocol and the EAPS domain.
  2. Confirm that the master node is in Complete state and its secondary port is blocking.

    Switch 1 commands to enable EAPS and the domain:

    * SWITCH#1.10 # enable eaps
    * SWITCH#1.11 # enable eaps new-eaps

    Switch 2 commands to enable EAPS and verify status:

    * SWITCH#2.10 # enable eaps
    * SWITCH#2.11 # enable eaps new-eaps
    * SWITCH#2.12 # show eaps
    EAPS Enabled: Yes
    EAPS Fast-Convergence: Off
    EAPS Display Config Warnings: On
    EAPS Multicast Add Ring Ports: Off
    EAPS Multicast Send IGMP Query: On
    EAPS Multicast Temporary Flooding: Off
    EAPS Multicast Temporary Flooding Duration: 15 sec
    Number of EAPS instances: 1
    # EAPS domain configuration :
    ----------------------------------------------------------------------------
    Domain         State           Mo  En  Pri   Sec   Control-Vlan VID   Count
    ----------------------------------------------------------------------------
    new-eaps       Complete        M   Y   4:1   4:2   control-1    (4001) 0
    ----------------------------------------------------------------------------