Configuring Route Compression

To enable route compression for IPv4 routes, use the following command:
enable iproute compression {vr vrname}
To disable route compression for IPv4 routes, use the following command:
disable iproute compression {vr vrname}

When you enable or disable route compression, that process is performed in chunks, rather than as one single processing event. Because the ExtremeXOS Route Manager processes a limited number of IP prefixes per second, route compression should not have any significant impact on performance. Likewise, when IP route compression is enabled, incremental route addition or deletion should not have a significant impact on performance.

Note

You should disable iproute compression if MPLS (Multiprotocol Label Switching) next hop is enabled on the switch.

Note

IP route is enabled by default.

Published March 2020prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback