Disabling EAPS Loop Protection Warning Messages

The switch displays by default loop protection messages when configuring the following EAPS (Extreme Automatic Protection Switching) parameters:

Adding EAPS primary or secondary ring ports to a VLAN (Virtual LAN)
Deleting a protected VLAN
Disabling the global EAPS setting on the switch
Disabling an EAPS domain
Configuring an EAPS domain as a transit node
Unconfiguring EAPS primary or secondary ring ports from an EAPS domain

We recommend keeping the loop protection warning messages enabled. If you have considerable knowledge and experience with EAPS, you might find the EAPS loop protection warning messages unnecessary. For example, if you use a script to configure your EAPS settings, disabling the warning messages allows you to configure EAPS without replying to each interactive yes/no question.

To disable loop protection messages, use the following command:
configure eaps config-warnings off
To re-enable loop protection messages, use the following command:
configure eaps config-warnings on

Published March 2020prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback