This command allows the clearing of the out-of-profile status and rate-limit counter for meters that have been exceeded. For an input meter and the entered ports, the status option will remove the ports from the disabled port out-of-profile list for the entered meter, re-enable ports that may have been disabled due to the out-of-profile meter, and re-enable the syslog and traps for those ports as well. For an input meter and the entered ports, the counter option will reset the counters. If the neither the status nor counter option is specified, both will be cleared. If the disabled-ports options is specified, only the out-of-profile meters that have disabled ports will be cleared. If no options are specified, all the out-of-profile status and counters will be cleared. If no ports are specified, the command clears the out-of-profile counter for a global meter. Note that the effected counter and status are the aggregates of the rule based counters for both ACL (Access Control List) and dot1p rules.
| metername | Meter name. |
| disabled-ports | Clear only the meter out-of-profile status that resulted in disabled-port action. |
| status | Clear only the meter out-of-profile status. |
| counters | Clear only the meter counters. |
| ports | Clear the meter applied to a specified port-list. |
| all | Clear meter out-of-profile status on all ports. |
| portlist | Port list separated by a comma or -. |
| port_group | Port group name. |
N/A.
None.
clear meter out-of-profile clear meter inmeter1 out-of-profile ports 1-5
This command was first available in ExtremeXOS 16.1.
This command is availabe on all platforms.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB