Enables the generation of an ICMP (Internet Control Message Protocol) address-mask reply on one or all VLAN (Virtual LAN)s.
| name | Specifies a VLAN name. |
Disabled.
Enables the generation of an ICMP address-mask reply (type 18, code 0) when an ICMP address mask request is received. The default setting is disabled. If a VLAN is not specified, the command applies to all IP interfaces.
This command only affects the generation of certain ICMP packets. Filtering of ICMP packets usually forwarded by the switch is controlled by the access-list commands.
The following example enables the generation of an ICMP address-mask reply on VLAN accounting:
enable icmp address-mask vlan accounting
This command was first available in ExtremeXOS 10.1.
The default was changed to disabled in ExtremeXOS 11.0.
This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X620, X690, X870 series switches.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB