Configures the other stateful configuration flag value sent in router discovery advertisements on the VLAN (Virtual LAN).
| vlan_name | Specifies an IPv6 configured VLAN. |
| on_off | Specifies setting the flag to on or off. |
Off.
This command configures the contents of the other stateful configuration flag in the router advertisement messages.
When set to on, hosts use the administered (stateful) protocol (DHCP (Dynamic Host Configuration Protocol)) for autoconfiguration of other (non-address) information. If this command is not entered, the default value is off.
The following example configures the other stateful configuration flag to be on for the VLAN "top_floor":
configure vlan top_floor router-discovery other-config-flag on
This command was first available in ExtremeXOS 11.2.
This command is available on the platforms listed for the IPv6 unicast routing feature in the ExtremeXOS 22.4 Feature License Requirements document.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB