show twamp endpoint

show twamp endpoint {ipaddress ip {port udp_port}}

Description

This command displays the endpoint configured values, run-time data, and test session information.

Syntax Description

ipaddress	The endpoint IP address, either IPv4 or IPv6.
`ip`	Specifies the endpoint IP address.
port	Specifies the endpoint port.
`udp-port`	The UDP port the endpoint will listen on; range is 1025 – 65535.

Default

N/A.

Usage Guidelines

None.

Example

# show twamp endpoint ipaddress 19.1.1.100 port 5000

 TWAMP Endpoint  
        
    Endpoint Information    
      Local Address:              19.1.1.100  Listening Port:                 5000
      Received Packets:                 7948  Transmitted Packets:            7948
      Active Sessions:                     5 
         
    Session created on Thu Nov 13 15:41:49 2014
      Peer Address:                 19.1.1.2  Port:                          11001
      Sequence Number:                  1575  Last recv'd packet:             84ms  

    Session created on Thu Nov 13 15:41:49 2014    
      Peer Address:                 19.1.1.2  Port:                          11002
      Sequence Number:                  1555  Last recv'd packet:              16ms  

    Session created on Thu Nov 13 15:41:49 2014

History

This command was first available in ExtremeXOS 16.1.

Platform Availability

This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X620, X690, X870 series switches.

Published December 2017prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback