Displays the status of the nodes in the system as well as the general health of the system.
| detail | Displays the information on a per-node basis rather than in a tabular format. |
N/A.
Use this command to display the current status of the nodes and the health of the system. The information displayed shows the node configurations (such as node priority) and the system and hardware health computations. You can use this information to determine which node will be elected primary in case of a failover.
Node States
| Node State | Description |
|---|---|
|
BACKUP |
In the backup state, this node becomes the primary node if the primary fails or enters the DOWN state. The backup node also receives the checkpoint state data from the primary. |
|
DOWN |
In the down state, the node is not available to participate in leader election. The node enters this state during any user action, other than a failure, that makes the node unavailable for management. Examples of user actions are:
|
|
FAIL |
In the fail state, the node has failed and needs to be restarted or repaired. The node reaches this state if the system has a hardware or software failure. |
|
INIT |
In the initial state, the node is being initialized. A node stays in this state when it is coming up and remains in this state until it has been fully initialized. Being fully initialized means that all of the hardware has been initialized correctly and there are no diagnostic faults. |
|
MASTER |
In the primary state, the node is responsible for all switch management functions. |
|
STANDBY |
In the standby state, leader election occurs—the primary and backup nodes are elected. The priority of the node is only significant in the standby state. |
The following command displays the status of the node, the priority of the node, and the general health of the system:
show node
The following is sample output from this command:
Node State Priority SwHealth HwHealth ----------------------------------------------- 1 MASTER 0 49 7 2 BACKUP 0 49 7
If you specify the detail option, the same information is displayed on a per node basis rather than in a tabular format, as shown in the following example:
Node 1 information: Node State: MASTER Node Priority: 0 Sw Health: 49 Hw Health: 7 Node MSM-B information: Node State: BACKUP Node Priority: 0 Sw Health: 49 Hw Health: 7
This command was first available in an ExtremeXOS 10.1.
This command is available only on SummitStack.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB