Displays all LACP, or dynamic link aggregation, counters for all member ports in the system.
This command has no parameters or variables.
N/A.
LACP PDUs dropped on non-LACP ports.
LACP bulk checkpointed messages sent.
LACP bulk checkpointed messages received.
LACP PDUs checkpointed sent.
LACP PDUs checkpointed received.
LAG (Link Aggregation Group) group ID.
Member port.
Packets received.
Packets dropped from PDU error.
Packets dropped because LACP is not enabled on this port.
Packets dropped because sender‘s system MAC address matches that of receiver.
Packets successfully transmitted.
Packets with errors during transmission.
The following command displays LACP counters:
show lacp counters
The following is sample output from this command on a switch:
LACP PDUs dropped on non-LACP ports : 519392 LACP Bulk checkpointed msgs sent : 1 LACP Bulk checkpointed msgs recv : 0 LACP PDUs checkpointed sent : 575616 LACP PDUs checkpointed recv : 0 Lag Member Rx Rx Drop Rx Drop Rx Drop Tx Tx Group Port Ok PDU Err Not Up Same MAC Sent Ok Xmit Err -------------------------------------------------------------------------------- 1:1 1:1 2169 0 0 0 2170 0 1:2 2169 0 0 0 2170 0 1:3 2169 0 0 0 2170 0 1:4 2169 0 0 0 2170 0 1:5 2169 0 0 0 2170 0 1:6 2169 0 0 0 2170 0 1:7 2169 0 0 0 2170 0 1:8 2168 0 0 0 2169 0 ================================================================================
This command was first available in ExtremeXOS 11.4.
This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X620, X690, X870 series switches.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB