configure ntp server/peer add

configure ntp [server | peer] add [ip_address | host_name] {key keyid} {option [burst | initial-burst]} {{vr} vr_name}

Description

Configures an NTP server or peer.

`ip_address`	Specifies the IP address of the NTP server or peer.
`host_name`	Specifies the host name of the NTP server or peer.
`keyid`	Specifies the key ID as a value from 1 to 65534.
burst	Follows the same burst mechanism when an NTP server is reachable.
initial-burst	Allows the system to send six burst packets when an NTP server becomes unreachable (discovered but unreachable).
vr	Specifies VR.
`vr_name`	Specifies the VR name. If no VR name is specified, the current command context is used.

If no VR name is specified, the current command context is used.

The initial-burst option is useful when a fast time synchronization is required at the initial stage.

The following command adds an NTP server named “Missouri” with key 5 and an initial burst:

configure ntp server add Missouri key 5 initial-burst

This command was first available in ExtremeXOS 12.7.

The vr keyword was added in ExtremeXOS 22.2.

This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X620, X690, X870 series switches.

Published December 2017prev | next