Configures the switching mode as either cut-through or store-and-forward.
| cut-through | Specifies that a packet can begin being transmitted prior to its being received in full. |
| store-and-forward | Specifies that a packet is transmitted only after the entire packet has been received and stored in the packet memory. |
Store-and-forward.
Use this command to configure the switch to begin transmitting a packet before its entire contents have been received. This reduces the forwarding latency of the switch.
Cut-through mode cannot be achieved for packet sizes that are less than or equal to 384 bytes. On the Summit X770 and X670-G2, cut-through can be achieved for all packet sizes.
ExtremeSwitching X690 supports cut-through switching on 40G ports only.
To display the switch mode settings, use the show forwarding configuration command.
This command was first available in ExtremeXOS 12.3.
This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X620, X690, X870 series switches.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB