This command allows you to add or remove remote VTEPs to a MAC address.
| mac_addr | Forwarding destination(s) for this MAC. |
| broadcast | Forwarding destination(s) for broadcast traffic. |
| unknown-unicast | Forwarding destination(s) for unknown unicast traffic. |
| unknown-multicast | Forwarding destination(s) for unknown multicast traffic. |
| add | Add to configuration. |
| delete | Delete from configuration. |
| vr | VR/VRF instance the IPv4 address is configured on. |
| vr_name | An existing VR/VRF name. |
| ipaddress | Configure the IP address of the remote tunnel endpoint to which the MAC needs to be bound. |
| remote_ipaddress | IPv4 address of the remote tunnel endpoint. |
You must first use the “[create | delete] fdb” command to add the first remote VTEP, and then issue this command to add additional remote VTEPs for the same MAC. You cannot add a remote VTEP to a static entry that has ports or blackhole configured. When the last VTEP is deleted, ExtremeXOS deletes the FDB (forwarding database) entry for that MAC.
configure fdb 01:00:5e:00:00:01 vlan vlan101 add vxlan ipaddress 30.30.30.1 configure fdb broadcast vlan vlan101 add vxlan vr VR-Default ipaddress 30.30.30.1 configure fdb unknown-unicast vlan vlan101 delete vxlan ipaddress 20.20.20.1
This command was first available in ExtremeXOS 21.1.
This command is supported on the Summit X770, X670-G2, and ExtremeSwiching X870, X690 series switches, and stacks with X770, X670-G2, X870, and X690 slots only.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB