show policy convergence-endpoint ports

show policy convergence-endpoint ports [port_list | all]

Description

This command displays the enable status of all supported Convergence End Point (CEP) types by port.

`port_list`	Shows enable status for the listed ports.
all	Shows enable status for all ports.

N/A

The following example shows the CEP enable status for port 3:

# show policy convergence-endpoint ports 3

Port        Cisco     LLDP-MED
----------  --------  --------
   3             enabled   disabled

This command was first available in ExtremeXOS 22.2.

This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X620, X690, X870 series switches.

Published December 2017prev | next