Configures the operation of the duplicate address detection (DAD) feature on the specified VR.
| max_solicitations | Specifies the number of times the DAD feature tests for a duplicate address. The range is 1 to 10, and the default value is 1. |
| vr_name | Specifies a VR on which to enable this feature. |
DAD status: Off on VR-Default.
Maximum solicitations: 1 on VR-Default.
If you do not specify a VR or VRF, the current VR context is used.
This command can be entered in a configuration file for execution at switch startup, or it can be entered at the CLI prompt.
Changes to the number of solicitations configuration take affect the next time the DAD check is run.
By default, this command applies to the current VR context, if no VR name is specified. If vr all is specified, the command applies to all user VRs and VR-Default.
The following command enables the DAD feature on all user VRs and VR-Default:
configure ip dad on vr all
This command was first available in ExtremeXOS 12.6.
This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X620, X690, X870 series switches.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB