configure stpd ports auto-edge

configure stpd stpd_name ports auto-edge [on | off] port_list

Description

Enables and disables auto-edge detection.

`stpd_name`	Specifies an STPD (Spanning Tree Domain) name on the switch.
on	Enables auto-edge detection on the specified port.
off	Disables auto-edge detection on the specified port.
`port_list`	Specifies one or more ports or slots and ports.

By default, auto-edge detection is on.

None.

The following example enables auto-edge detection on port 1:10 in STP (Spanning Tree Protocol) domain r1:

configure stpd r1 ports auto-edge on 1:10

This command was first available in ExtremeXOS 15.7.1.

This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X620, X690, X870 series switches.

Published December 2017prev | next