Configures the front panel LEDs to flash so a switch can be easily located in a crowded lab/data center.
| timeout |
Limit the LED display time to seconds before returning to normal operation. |
| seconds | The length of time to display the flashing LEDs. The default is 300 seconds. The maximum value is 1 week (604800 seconds). |
| none | Display LED pattern until disabled. |
| pattern | Configures the LED display pattern. |
| alternating | Groups of LEDs are lit in alternating patterns (Default). |
| flash-all | All LEDs flash on and off. |
| high-to-low | LED's are lit in descending port order. |
| scanner | A group of 4 LED's is lit back and forth. |
| slot slot | Slot number. |
| all | All slots. |
The default timeout length is 300 seconds.
The default pattern is alternating.
Use this command to enable the front panel LEDs to flash so that a switch can be easily located in a crowded lab, or data center.
The following example enables the front panel LEDs to flash in an alternating pattern for one hour on all slots:
enable led locator timeout 3600 pattern alternating all
This command was first available in ExtremeXOS 15.3.
This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X620, X690, X870 series switches.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB