Disables TCP and UDP ports checking.
| tcp | Specifies that the TCP port be disabled for checking. |
| udp | Specifies that the UDP port be disabled for checking. |
| both | Specifies both the TCP and UDP ports be disabled for checking. |
| slot | Specifies the slot to be used. |
| all | Specifies all IP addresses, or all IP addresses in a particular state. |
The default is disabled.
This command disables TCP and UDP ports checking. This checking takes effect for both IPv4 and IPv6 TCP and UDP packets. When enabled, the switch drops TCP and UDP packets if its source port is the same as its destination port. In most cases, when the condition of source port is the same as that of the destination port, it indicates a Layer4 protocol error. (This type of error can be found in a BALT attack.)
This command was first available in ExtremeXOS 12.0.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB