configure bfd vlan

configure bfd vlan vlan_name [{detection-multiplier multiplier} {receive-interval rx_interval} {transmit-interval tx_interval}]

Description

Configures BFD transmit (TX) and receive (RX) intervals and multipliers on the VLAN (Virtual LAN).

`vlan_name`	Specifies the VLAN.
`multiplier`	Specifies the detection multiplier. The range is 1 to 255.
`rx_interval`	Specifies the receive interval for control packets in milliseconds. The range is 100 to 4294967 ms. (3 to 4294967 ms if hardware assist is enabled).
`tx_interval`	Specifies the transmit interval for control packets in milliseconds. The range is 100 to 4294967 ms. (3 to 4294967 ms if hardware assist is enabled).

The default value for RX and TX intervals is 1000 ms.

The default value for the detection-multiplier is 3.

Use this command to configure BFD.

Use the show bfd vlan command to display the current settings.

The following command configures a transmit and receive interval of 2000 ms and a detection multiplier of 2 on the VLAN vlan1:

configure bfd vlan vlan1 detection-multiplier 2 receive-interval 2000 transmit-interval 2000

This command was first available in ExtremeXOS 12.4.

This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X620, X690, X870 series switches.

Published December 2017prev | next