Removes a policy file ACL (Access Control List) from the specified interface.
policy_name | Specifies the ACL policy name. The name can be from 1-32 characters long. |
port_list | Specifies the ingress or egress port list on which the ACL is applied. |
vlan_name | Specifies the VLAN (Virtual LAN) on which the ACL is applied. |
ingress | Remove the ACL for packets entering the switch on this interface. |
egress | Remove the ACL for packets leaving the switch from this interface |
The default direction is ingress.
This command removes ACLs that are contained in ACL policy files. To remove dynamic ACLs, use the following command:
configure access-list delete ruleName [ any | vlanvlan_name | portsport_list | all] {ingress | egress}
To remove all non-dynamic ACLs from all interfaces, do not specify any ports or VLANs.
The following command removes the ACL from port 1:2:
unconfigure access-list ports 1:2
The following command removes the ACLs from ports 1:2-6:3 and 7:1:
unconfigure access-list ports 1:2-6:3,7:1
The following command removes the wildcard ACL:
unconfigure access-list any
The following command removes all ACLs from all the interfaces, including the wildcard ACL:
unconfigure access-list
This command was first available in ExtremeXOS 10.1.
The VLAN option was first available in ExtremeXOS 11.0.
The egress option was first available in ExtremeXOS 11.3.
This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X620, X690, X870 series switches.
The egress options are available on all platforms.