configure port reflective-relay

configure port port reflective-relay [on | off]

Description

Enables the direct attach feature on the specified port.

port

Specifies a single port on which to enable the direct attach feature.

Off.

You should only enable the direct attach feature on ports that directly connect to a VM server running VEPA software.

This feature requires installation of the Direct Attach feature pack. For more information, see the ExtremeXOS 22.4 Feature License Requirements document..

The following command enables the direct attach feature on port 2:1:

configure port 2:1 reflective-relay on

This command was first available in ExtremeXOS 12.5.

This command is available on all Summit family switches.

Published December 2017prev | next