configure network-clock clock-source input

configure network-clock clock-source input {[sync-e | ptp |region [E1 | T1]}

Description

Configure the input network clock source as Sync-E or PTP. A region can also be configured using this command.

sync-e	Synchronous Ethernet (ITU-T standard) (Default).
ptp	Precision Time Protocol.
E1	Specifies the European and Asian clock region selection (Default).
T1	Specifies the North American clock region selection.

The default input clock source is Synchronous Ethernet. The default region is E1.

The Summit X460-G2 series switches have clock sources beyond SyncE. The clock which drives all of the ports on a switch may be selected from:

The following command configures the region as T1:

configure network-clock clock-source input region t1

The following command configures the network-clock source as TDM:

configure network-clock clock-source input tdm

This command was first available in ExtremeXOS 15.1.

This command is available on the Summit X460-G2 series switches.

Published December 2017prev | next