Resets the configuration parameters of the specified WAN PHY port to default values.
|
port_list |
Specifies the port number. On a stand-alone switch, this value is just the port number, and on a modular switch, this value is the slot and port number. |
|
all |
Specified all WAN PHY ports. |
N/A.
XFP ports must be in WAN PHY mode. To configure the mode, use the configure ports port_list mode {lan | wan-phy} command.
When the all option is used, the command constructs a port_list of all applicable ports—LW-XENPAK ports and/or XFP ports that have been WAN-PHY enabled.
Framing—SONET.
Clock source—line.
Section trace—the IEEE default value, which has no string representation.
Path trace—the IEEE default value, which has no string representation.
Loopback—off.
The following command unconfigures the configurable WAN PHY OAM parameters on a single LW XENPAK port on a modular switch:
unconfigure ports 2:1 wan-phy
This command was available in ExtremeXOS 11.6.
This command is available on all 10G ports on 10G XFP ports only on the Summit X480 series switches.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB