Configuring profile to be used for IKE Phase 1 policy

Use the following procedure to configure the IKE Phase1 profile to be used for the IKE Phase 1 policy.

Procedure

Enter Global Configuration mode:

enable

configure terminal
Configure the profile name to be used for IKE Phase 1 policy:

ike policy WORD<1–32> profile WORD<1–32>

The following table defines parameters for the ike policy WORD<1–32> profile WORD<1–32> command.


Variable	Value
policy `WORD<1–32>`	Specifies the name of the IKE Phase 1 policy.
profile `WORD<1–32>`	Specifies the name of the IKE Phase 1 profile to be used for the policy. To set this option to the default value, use the default operator with the command: default ike policy WORD<1-32> profile