Configure Multi-area SPB Layer 2 I-SID Redistribution

Note

Note

This procedure only applies to the VSP 7400 Series.

About this task

Perform this procedure to configure Multi-area SPB layer 2 I-SID redistribution.

Procedure

  1. Enter IS-IS Router Configuration mode:

    enable

    configure terminal

    router isis

  2. Configure the Multi-area SPB layer2 I-SID redistribution:

    multi-area l2 redistribute i-sid {deny-all | permit-all} [except-isid-list WORD<1-32>]

  3. Verify the Multi-area SPB layer2 I-SID redistribution configuration:

    show isis multi-area l2 redistribute i-sid

  4. Apply the layer 2 I-SID redistribution:

    isis multi-area l2 apply redistribute i-sid

Example

Configuring Multi-area SPB layer 2 I-SID redistribution and exclude the I-SID values specified in the I-SID list:

Switch:1>enable
Switch:1#configure terminal
Switch:1(config)#router isis
Switch:1(config-isis)#multi-area l2 redistribute i-sid permit-all except-isid-list testlist
Switch:1(config-isis)#show isis multi-area l2 redistribute i-sid
=========================================================================
                        MULTI AREA L2 ISID REDIST POLICY
=========================================================================
Permit               Except List Name
-------------------------------------------------------------------------
permit-all           testlist
-------------------------------------------------------------------------
Switch:1(config-isis)#isis multi-area l2 apply redistribute i-sid

Variable Definitions

The following table defines parameters for the multi-area l2 redistribute i-sid command.

Variable Value
deny-all

Denies the Multi-area SPB IPv6 unicast redistribution configuration for the specified I-SID list name.
except-isid-list WORD<1-32>

Specifies the name of the I-SID list.
permit-all

Permits the Multi-area SPB IPv6 unicast redistribution configuration for the specified I-SID list name.
9036843-01 Rev AD