Configure local port Auto-Negotiation advertisements to specify the speed and duplex mode for traffic between local ports and remote link partners. Supported speeds and duplex modes vary, depending on your hardware.

Configure Auto-Negotiation Advertisements

Configure local port Auto-Negotiation advertisements to specify the speed and duplex mode for traffic between local ports and remote link partners. Supported speeds and duplex modes vary, depending on your hardware.

Before you begin

You must enable Auto-Negotiation before you perform this procedure.

About this task

Configure local port Auto-Negotiation advertisements.

Procedure

  1. Enter GigabitEthernet Interface Configuration mode:

    enable

    configure terminal

    interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}

    Note

    Note

    If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

  2. Configure Auto-Negotiation advertisements on one or more ports:

    auto-negotiation-advertisements {10000-full|2500-full|5000-full|1000-full|100-full|100-half|10-full|10-half}

    or

    auto-negotiation-advertisements port {slot/port[/sub-port][-slot/port[/sub-port]][,...]}] {10000-full|2500-full|5000-full|1000-full|100-full|100-half|10-full|10-half}

  3. Verify the configuration:

    show interfaces gigabitEthernet l1-config [{slot/port[/sub-port][-slot/port[/sub-port]][,...]}]

Variable Definitions

The following table defines parameters for the auto-negotiation-advertisements command.

Variable

Value

{slot/port[/sub-port] [-slot/port[/sub-port]] [,...]}

Specifies the port or ports that you want to configure.

10000-full

Advertises 10000 Mbps full duplex.

5000-full

Advertises 5000 Mbps full duplex.

2500-full

Advertises 2500 Mbps full duplex.

1000-full

Advertises 1000 Mbps full duplex.

100-full

Advertises 10000 Mbps full duplex.

100-half

Advertises 10000 Mbps half duplex.

10-full

Advertises 10 Mbps full duplex.

10-half

Advertises 10 Mbps half duplex.

none

Configures the Auto-Negotiate value to none.