Display the Logical Interface IPsec Configurations on the Fabric IPsec Gateway VM

About this task

Perform this procedure to display the logical interface IPsec configurations on the Fabric IPsec Gateway Virtual Machine (VM):

1. Enter Fabric IPsec Gateway Configuration mode:

   enable

   virtual-service WORD<1-128> console

   

   Note

   Type CTRL+Y to exit the console.

2. Display the logical interface IPsec configurations on the VM:

   show logical-intf-config <1-255>

Example

Displaying the logical interface IPsec configurations on the on Fabric IPsec Gateway VM:

Switch:1> enable
Switch:1# virtual-service figw console
Connected to domain figw
Escape character is ^Y

  <cr>
FIGW>
FIGW> show logical-intf-config 1
logical-intf-tunnel {
    tunnel_id 1;
    tunnel-name ----;
    fe-tunnel-dest-ip 20.20.20.20;
    mtu 1950;
    egress-shaping-rate 110;