Configure a Community Access List
Configure community lists to specify permitted routes by using their BGP community. This list acts as a filter that matches communities or AS numbers.
Before you begin
Change the VRF instance as required to configure BGP on a specific VRF instance. The VRF must have an RP trigger of BGP. Not all parameters are configurable on non-default VRFs.
Procedure
- In the navigation pane, expand .
- Click Policy.
- Click the Community List tab.
- Click Insert.
- Configure the list as required.
- Click Insert.
Community List field descriptions
Use the data in the following table to use the Community List tab.
|
Name |
Description |
|---|---|
|
Id |
Specifies the community list. The range is 0–1024. |
|
MemberId |
Specifies the community list member ID. The range is 0–65535. |
|
Mode |
Specifies the action to take if the system selects a policy for a specific route. Select permit (allow the route) or deny (ignore the route). |
|
Community |
Specifies the community access list community string. |