iot-device-type-imagotag-policy

Note

This feature is supported only on AP's with USB ports. Ensure the AP is using PoE+ (802.3at) power for the USB port to be enabled.

ESL tags are small, battery-powered devices used by retail businesses to display information, such as product code, pricing, etc. These tags are activated, configured, and managed through an SES-Imagotag server. The tags and server communicate through an ESL communicator (a USB dongle) connected to the USB port on the WiNG AP. This communication is over the 2.4 GHz band using a proprietary RF protocol. The ESL communicator acts as a bridge between the tags and the server, using WiNG AP as an infrastructure device.

This policy enables the ESL communicator, identifies the Imagotag server host, configures the payload size, etc. Apply the policy to the AP‘s self (in case of stand alone AP) or profile context. When applied to the profile, the policy is pushed to the AP through the adopting controller.

Note

On the Imagotag server, configure the WiNG AP's ID. This enables the server identify the WiNG AP. Use the show > iot-device-type-imagotag > status command to obtain the WiNG AP's ID. Refer to the Imagotag server configuration guide for more information.

Supported in the following platforms:

• Access Points — AP310i/e, AP410i/e, AP460i/e, AP505i, AP510i/e, AP560i/e, AP8432
• Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax

iot-device-type-imagotag-policy <POLICY-NAME>

Parameters

iot-device-type-imagotag-policy <POLICY-NAME>

Example

nx9500-6C8809(config)#iot-device-type-imagotag-policy ImagoTagPolicy
nx9500-6C8809(config-iot-device-type-imagotag-policy-ImagoTagPolicy)#?
Iot Imagotag Policy Mode commands:
  channel       Auto channel selection
  enable        Enable ESL communicator
  fcc-mode      Enable fcc compatibility mode on ESL communicator
  no            Negate a command or set its defaults
  output-power  Maximum output power
  payload-size  Configure payload size
  server        ESL server
  ssl           Enable ssl on ESL communicator
  window-size   Configure window size

  clrscr        Clears the display screen
  commit        Commit all changes made in this session
  do            Run commands from Exec mode
  end           End current mode and change to EXEC mode
  exit          End current mode and down to previous mode
  help          Description of the interactive help system
  revert        Revert changes
  service       Service Commands
  show          Show running system information
  write         Write running configuration to memory or terminal

nx9500-6C8809(config-iot-device-type-imagotag-policy-ImagoTagPolicy)#

Related Commands