halt

Stops (halts) a device (access point, wireless controller, or service platform). Once halted, the system must be restarted manually.

This command stops the device immediately. No indications or notifications are provided while the device shuts down.

Supported in the following platforms:

Access Points — AP310i/e, AP410i/e, AP460i/e, AP560i/h, AP510i/e, AP505i, AP7522, AP7532, AP7562, AP7612, AP7632, AP7662, AP8432, AP8533
Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

halt force {on <DEVICE-NAME>}

halt force {on <DEVICE-NAME>}


halt	Halts a device
force	Optional. Forces a device to halt ignoring in-progress operations, such as firmware upgrades, downloads, unsaved configuration changes, etc.
	The following keywords are recursive and applicable to the ‘force‘ parameter: on <DEVICE-NAME> – Optional. Specifies the name of the device to be halted <DEVICE-NAME> – Enter the name of the AP, wireless controller, or service platform. Note: If the device name is not specified, the logged device is halted.

nx9500-6C8809#halt on ap505-134038