timers (bgp-router-config)
Enables adjustment of keepalive and holdtime intervals
Supported in the following platforms:
- Service Platforms — NX9500, NX9600
Syntax
timers bgp <0-65535> <0-65535>
Parameters
timers bgp <0-65535> <0-65535>
| timers bgp <0-65535> <0-65535> |
Configures the keepalive and holdtime interval in
seconds
- <0-65535> – Specify a keepalive interval from 0 - 65535 seconds. It is the
interval, in seconds, between two successive keepalive packets exchanged with
this router and its neighbor to keep the TCP connection alive.
- <0-65535> – Specify a holdtime value from 0 - 65535 seconds. This is
the time this router will wait without receiving a keepalive packet from its
neighbor before declaring it dead. If the time since the last keepalive
packet received (from its neighbor) exceeds the value set here, the neighbor
is declared dead.
|
Examples
nx9500-6C8809(config-device B4-C7-99-6C-88-09-router-bgp)#timers bgp 100 100
nx9500-6C8809(config-device B4-C7-99-6C-88-09-router-bgp)#show context
router bgp
bgp enable
asn 1
aggregate-address 116.117.118.0/24 as-set summary-only
bgp neighbor 192.168.13.199
remote-as 1
use route-map UnSupMap_01 in
bgp neighbor 192.168.13.99
remote-as 199
maximum-prefix 9999 80 restart 50
timers bgp 100 100
bgp-route-limit num-routes 10 reset-time 360
nx9500-6C8809(config-device B4-C7-99-6C-88-09-router-bgp)#
