no

Negates a command or reverts values to their default. When used in the config MiNT policy mode, the no command resets or reverts the following global MiNT policy parameters: routing level, MTU, router packet priority, and UDP or IP encapsulation settings.

Supported in the following platforms:

Access Points — AP310i/e, AP410i/e, AP460i/e, AP560i/h, AP510i/e, AP505i, AP7522, AP7532, AP7562, AP7612, AP7632, AP7662, AP8432, AP8533
Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax

no [level|lsp|mtu|router|udp]

no level 2 area-id

no lsp checksum

no mtu

no router packet priority

no udp port <LINE-SINK>

Parameters

no <PARAMETERS>


no <PARAMETERS>	The no command resets or reverts the following global MiNT policy parameters: routing level, MTU, router packet priority, and UDP or IP encapsulation settings.

Examples

The following example shows the global Mint Policy parameters before the ‘no‘ commands are executed:

nx9500-6C8809(config-mint-policy-global-default)#show context
mint-policy global-default
 udp port 1024
 mtu 996
 level 2 area-id 2000
 sign-unknown-device
 security-level control-and-data
 rejoin-timeout 1000
nx9500-6C8809(config-mint-policy-global-default)#

nx9500-6C8809(config-mint-policy-global-default)#no level 2 area-id

nx9500-6C8809(config-mint-policy-global-default)#no mtu

nx9500-6C8809(config-mint-policy-global-default)#no udp port

The following example shows the global Mint Policy parameters after the ‘no‘ commands are executed:

nx9500-6C8809(config-mint-policy-global-default)#show context
mint-policy global-default
 sign-unknown-device
 security-level control-and-data
 rejoin-timeout 1000
nx9500-6C8809(config-mint-policy-global-default)#