failover-delay

Configures the L2TPV3 tunnel failover delay in seconds. This is the interval after which a failed over tunnel is re-established.

Supported in the following platforms:

Access Points — AP310i/e, AP410i/e, AP460i/e, AP560i/h, AP510i/e, AP505i, AP7522, AP7532, AP7562, AP7612, AP7632, AP7662, AP8432, AP8533
Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax

fail-over <5-60>

Parameters

fail-over <5-60>


fail-over <5-60>	Sets the delay interval to re-establish a failed L2TPV3 tunnel (RF-Domain manager/ VRRP-master/Cluster-master failover) <5-60> – Specify a fail-over delay from 5 - 60 seconds. The default is 5 seconds.

Examples

nx9500-6C8809(config-l2tpv3-policy-L2TPV3Policy1)#failover-delay 30

nx9500-6C8809(config-l2tpv3-policy-L2TPV3Policy1)#show context
l2tpv3 policy L2TPV3Policy1
 hello-interval 200
 failover-delay 30
 retry-attempts 10
 retry-interval 30
 cookie-size 8
 rx-window-size 9
 tx-window-size 9
 reconnect-interval 100
 reconnect-attempts 8
nx9500-6C8809(config-l2tpv3-policy-L2TPV3Policy1)#

Related Commands


no	Resets the failover interval to its default (5 seconds)