floor

Profile Config Commands

Sets the floor name where the target device (access point, wireless controller, or service platform using this profile) is physically located. Assigning a building floor name helps in grouping devices within the same general coverage area.

Supported in the following platforms:

Access Points — AP310i/e, AP410i/e, AP460i/e, AP560i/h, AP510i/e, AP505i, AP7522, AP7532, AP7562, AP7612, AP7632, AP7662, AP8432, AP8533
Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax

floor <WORD> {<1-4094>}

Parameters

floor <WORD> {<1-4094>}


floor <WORD> {<1-4094>}	Sets the floor name where the target device is located <WORD> – Specify the floor name (should not exceed 64 characters in length). <1-4094> – Optional. Configures the floor number from 1 - 4094. The default is 1.

Example

nx9500-6C8809(config-profile-default-ap410)#floor fifth

nx9500-6C8809(config-profile-default-ap410)#show context
profile ap410 default-ap410
 bridge vlan 1
  ip igmp snooping
  ip igmp snooping querier
 area Ecospace
 floor fifth
 autoinstall configuration
 autoinstall firmware
--More--
nx9500-6C8809(config-profile-default-ap410)#

Related Commands


no	Resets the configured floor name and number