path-method [bound-pair|mobile-snr-leaf|snr-leaf|uniform]
path-method [bound-pair|mobile-snr-leaf|snr-leaf|uniform]
| path-method | Sets the method used to select the path to the root node in a mesh network |
| bound-path | Enables a meshpoint to form an exclusive path with only one other meshpoint. Select this option to bind one mesh point connection at a time. Once established, other mesh point connection requests are denied. |
| mobile-snr-leaf | Configures the path selection method as mobile-snr-leaf. When selected,
the path to the root node is selected based on the Signal-to-Noise
Ratio (SNR) to a neighboring device. This option allows meshpoint
devices to select a neighbor with the strongest SNR. Meshpoint devices using
the mobile-snr-leaf method are non-forwarding nodes in the meshpoint
traffic. Note: Select this
option for Vehicular Mounted Modem (VMM) access points or
other mobile devices.
|
| snr-leaf | This option allows meshpoints to select a neighbor with the strongest SNR. It is similar to the mobile-snr-leaf option, but is not applicable to mobile devices, such as VMMs. |
| uniform | Indicates the path selection method is uniform. When selected, two paths
will be considered equivalent if the average goodput is the same for both
paths. This is the default setting. Note: Select this option for
infrastructure devices.
|
nx9500-6C8809(config-profile-AP8533TestProfile-meshpoint-test)#path-method mobile-snr-leaf
nx9500-6C8809(config-profile-AP8533TestProfile-meshpoint-test)#show context meshpoint-device TEST name TEST path-method mobile-snr-leaf nx9500-6C8809(config-profile-AP8533TestProfile-meshpoint-test)#