threshold-client

Configures the client threshold limit. This is the threshold limit per client that, when exceeded, signals the event.

Supported in the following platforms:

Access Points — AP310i/e, AP410i/e, AP460i/e, AP560i/h, AP510i/e, AP505i, AP7522, AP7532, AP7562, AP7612, AP7632, AP7662, AP8432, AP8533
Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax

threshold-client <1-65535>

Parameters

threshold-client <1-65535>


threshold-client <1-65535>	Configures the client threshold limit <1-65535> – Set the threshold limit for a 60 second window from 1 - 65535.

Examples

nx9500-6C8809(config-test-signature-test)#threshold-client 88

nx9500-6C8809(config-test-signature-test)#show context
 signature test
  bssid 11-22-33-44-55-66
  src-mac 00-1E-E5-EA-1D-60
  dst-mac 55-66-77-88-99-00
  frame-type beacon
  ssid-match ssid PrinterLan
  filter-ageout 8
  threshold-client 88
  payload 1 pattern test offset 1
nx9500-6C8809(config-test-signature-test)#

Related Commands


no (wips-signature-config-mode-command)	Removes the client threshold limit configured with a WIPS policy signature