dpd-keepalive

crypto-ikev1/ikev2-policy commands

Sets the DPD keep-alive packet interval

Supported in the following platforms:

  • Access Points — AP505i, AP510i/e, AP560i/h
  • Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax

dpd-keepalive <10-3600>

Parameters

dpd-keepalive <10-3600>
<10-3600> Specifies the interval, in seconds, between successive DPD keep alive packets.The IKE keep alive message is used to detect a dead peer on the remote end of the IPSec VPN tunnel. Specify the time from 10 - 3600 seconds. The default is 30 seconds.

Example

nx9500-6C8809(config-profile-default-rfs4000-ikev1-policy-ikev1-testpolicy)#dpd-keepalive 11

nx9500-6C8809(config-profile-default-rfs4000-ikev1-policy-testpolicy)#show context
 crypto ikev1 policy testpolicy
  dpd-keepalive 11
  isakmp-proposal default encryption aes-256 group 2 hash sha
nx9500-6C8809(config-profile-default-rfs4000-ikev1-policy-testpolicy)#